K149130A Replacement Tube

For Evictor Strobe Light®10K
175,000 Candle Power

K149130A Replacement Tube
For Evictor Strobe Light®10K

Test on occasion for strobe tube degradation.

Must the strobe tube misfire, have a noticeable decrease in light output, glow often, or darken – replacement or repair could also be vital.

REPLACEMENT INSTRUCTIONS

Disconnect power from provide circuit and wait a minimum of 5 mins before opening the unit to permit all capacitors to discharge.

Eliminate the screw situated at the bottom of the dome.

Snatch the highest of the dome and push down even as turning the dome counter-clockwise approximately ¾”.

Lightly lift the dome away. Make certain that the gasket between the dome and the bottom isn’t lost.

Snatch the strobe tube by its base and pull it out of the socket, the use of a steady rocking motion.

Insert a brand new strobe tube.

Before replacing the dome, Make certain that the gasket is correctly seated at the housing base. Place the dome over the bottom, align the recesses throughout the dome lip with the four pins at the base. Push down at the dome and switch it clockwise unit it locks in place.

Replace the screw within the bottom of the dome.

Check the Evictor Strobe Light® for correct operation.
For Evictor Strobe Light®10K
175,000 Candle Power

Binding

Brand

EAN

EANList

Model

MPN

PackageDimensions

PackageQuantity

PartNumber

ProductGroup

ProductTypeName

UPC

UPCList

Reviews

There are no reviews yet.

Be the first to review “K149130A Replacement Tube”

Your email address will not be published. Required fields are marked *